Filter
Top Products
www.aleratec.com
7
Using the HDD Copy Dock Duplicator
Duplicator Mode
Main Menu: Copy HDD
The “Copy HDD” function performs an actual copy from the source HDD to
the target HDD. The target HDD must be at least as large as the source. The
HDD Copy Dock Duplicator will copy every block of capacity on the source
HDD.
1. Load the source HDD and the target HDD(s) into the HDD Copy Dock
Duplicator. The system will auto-detect the hard drives. After the drives
have been detected, a screen similar to the one below will be displayed:
Note: Before copying be sure that the capacity of the target HDD is equal to
or larger than the source hard drive.
2. Press ENT to start copying. The system will auto-detect the hard drives.
3. During the copy process the HDD Copy Dock Duplicator will display
progress information.
The amount of data remaining to be transferred (shown in gigabytes),
and time will be displayed in increasing increments as the percentage of
completion increases. The process information is refreshed every 15 to 20
seconds.
Note: The copying speed, capacity and duration may vary from one source
hard drive to another.
4. Once duplication is complete, a job status screen will be displayed:
HDD Duplicator
1-1 ver:
UP
DOWN
ENT
ESC
POWER
HDD Duplicator
1-1 ver:
UP
DOWN
ENT
ESC
POWER
HDD Duplicator
1-1 ver:
UP
DOWN
ENT
ESC
POWER
== Dup. Menu ==
1. Copy HDD
Copy - 36MB/s 0%
235.7GB 00:01:48
Final 38 MB/s 100%
0.0 GB 00:32:57