Filter
Top Products
www.aleratec.com
18
Specifications
Power Requirements Voltage: 100-240V
Current: 50-60Hz
Dimensions
(depth x width x height)
D: 201mm W: 210mm H: 120.3mm
(7.9” x 8.3” x 4.7”)
Weight 1.02kg (2.2 Lbs.)
Note: Specifications subject to change without notice.
Troubleshooting
If your HDD Copy Dock Duplicator is not performing as expected, refer to the
symptoms below, and follow the suggested corrective action.
Symptoms Corrective Actions
LCD Display If the LCD display does not display any message and
the backlight is not lit after powering on the HDD Copy
Dock Duplicator, check that the power cable is properly
connected and that the ON/OFF switch is turned on.
Error Messages While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the HDD Copy Dock Duplicator
to stop responding. If this happens, power the unit off, wait
about ten (10) seconds, and then reapply power.
Hard Disk If the HDD Copy Dock Duplicator does not detect one
of the hard disk drives, verify that the drive is properly
connected. Power off all HDD’s. Wait 10 seconds then
power on.
Keypad Buttons If pressing the keys on the front panel produces no
response from the system, the HDD Copy Dock Duplicator
may still be busy with the previous operation. If the system
is idle, power the unit off, wait about ten (10) seconds, and
then reapply power.
Startup/Shutdown Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.