Filter
Top Products
57
Configuring DHCP Server
1. To use the DHCP server inside the device, please make sure there is no other
DHCP server existed in the same network as the device.
2. Enable the DHCP Server option and assign the client range of IP addresses as
following page.
3. When the DHCP server is enabled and also the device router mode is enabled
then the default gateway for all the DHCP client hosts will set to the IP address
of device.
Using CLI Menu
Start a SSH(Secure Shell) client session to login the device
The SSH server daemon inside device uses well-known TCP port 22.
User must use SSH client utility such like Putty to login the device. The
default password for user “root” is “qwert”, once user login the device
then can change the password by CLI command.
Execute CLI program
This program won’t execute automatically when user login the device.
User must manually execute it by typing the case-sensitive command
“cli”. Please note that any modified settings won’t save permanently
until user “Apply Changes to Flash” or reboot it. The new settings
modified by CLI will take effect after rebooting the device.
Menu Tree List