Filter
Top Products
AT-S94 Version 3.0.0.41 Software Release Notes
PN 613-001480 Rev A 5 Allied Telesis, Inc.
Version 3.0.0.41 Upgrade Process
You must have the correct software and bootloader installed on your switch before beginning the
upgrade process to Version 3.0.0.41. Perform the following procedure:
Note
If you have a stacked configuration, all switches must be running the latest bootloader and
the same software version before you upgrade the software for the stack.
Note
You can download Version 3.0.0.41 files from our web site at www.alliedtelesis.com.
Refer to “Management Software Updates” on page 16 for instructions on how to navigate
to the software updates page for the AT-8000S. All of the file names referenced below are
contained in the zip file that you download.
1. Log into the switch.
2. For a successful software upgrade of your AT-8000S switch, it is mandatory that you first
install the latest boot loader file (s94bv10107.rfb). You can find this file in the
Latest_Boot_Loader folder that you have downloaded from the Allied Telesis web site.
3. Verify that your switches are running the correct boot loader and management software by
using the following command:
show version
4. If your AT-8000S series switch has Version 1.0.0.25 (or earlier) currently installed on it, go to
the “Upgrade Procedure from Version 1.0.0.25” on page 12. and follow the steps to upgrade
to Version 3.0.0.41. If your AT-8000S series switch has Version 1.1.0.32 or later installed on
it, go to the next step to upgrade to Version 3.0.0.41.
5. With information displayed from the “show version” command, copy the boot version number
exactly as shown. Using this number as the password, extract the ats94-30041.ros software
upgrade file from the ats94-30041.zip file.