Filter
Top Products
Chapter 2: Installation
32
Installing the Switch on a Table or Desktop
To install the switch on a table or desktop, perform the following
procedure:
1. Remove all the items from the packaging and store the packaging
material in a safe place. In the event a problem occurs and you need
to return the unit, please use as much of the original shipping material
as possible.
2. Attach the four self-adhesive rubber feet to the bottom of the switch, as
shown in Figure 5.
Figure 5. Attaching the Rubber Feet
3. Place the switch on a flat and secure surface, leaving ample space
around the switch for ventilation.
4. Connected the twisted pair cables to the twisted pair ports.
When connecting a twisted pair cable to a port, observe the following
guidelines:
An RJ-45 connector should fit snugly into the port on the switch.
The tab on the connector should lock the connector into place.
Check that you are using the appropriate type of twisted pair
cabling. Refer to “Twisted Pair Cabling and Distances” on page 30
for twisted pair cable specifications.
Since the twisted pair port, when operating in Auto-Negotiation, is
Auto MDI/MDI-X, you can use either a straight-through or
crossover twisted pair cable to connect any type of network device
to a port on the switch. If you disable Auto-Negotiation on the port,
the port defaults to MDI-X.
24 Port 10/100/1000Base-T Gigabit Ethernet Switch
1357911131517192123
24
6 8 10 12 14 16 18 20 22 24
18 20 22 24
10 12 14 162468
91113151357
17 19 21 23
POWER
10/100 LINK
ACT
1000 LINK
ACT
FDX HDX
COL
AT-GS900/24
1897