Filter
Top Products
Chapter 7: Powering On the Chassis
158
Powering on the AT-SBxPWRPOE1 AC Power Supply
This section contains instructions on how to power on the AT-
SBxPWRPOE1 AC Power Supply. For installation instructions, refer to
“Installing the AT-SBxPWRPOE1 AC Power Supply” on page 101. To
power on the power supply, perform the following procedure:
1. Identify AC sockets A and B in the recessed panel on the back panel
of the chassis, shown in Figure 108 on page 155. The sockets are for
the AT-SBxPWRPOE1 Power Supplies in slots A and B on the front
panel of the chassis.
2. Plug the AC power cord that comes with the power supply into one of
the plugs, as shown in Figure 111.
The plug should have a power supply in the corresponding slot in the
front panel. If the chassis has two AT-SBxPWRPOE1 Power Supplies,
you may power on either supply first.
Figure 111. Connecting the AC Power Cord for the AT-SBxPWRPOE1
Power Supply