Filter
Top Products
SwitchBlade x3112 Installation Guide
145
Note
Do not remove the dust plug from a SFP+ slot if you are not
installing the transceiver at this time. The dust plug protects the line
card from dust contamination.
2. Orient the connector on the AT-SP10TW cable so that the release tab
is on top, as shown in Figure 101.
Figure 101. Release Tab on the AT-SBx31XS6 Line Card
3. Slide the connector into the slot until it clicks into place, as shown in
Figure 102.
Figure 102. Installing the AT-SP10TW Cable in the AT-SBx31XS6 Line
Card
Release Tab