Filter
Top Products
SwitchBlade x3112 Installation Guide
121
3. Align the line card with the internal chassis card guides in the selected
slot of the AT-SBx3112 Chassis.
Figure 78 shows an Ethernet line card aligned with slot 0.
Figure 78. Aligning an Ethernet Line Card in a Chassis Slot
4. Insert the line card into the slot, as shown in Figure 79 on page 122,
until the faceplate is firmly seated against the chassis front panel.
Caution
Forcing the line card into its chassis slot when it is not properly
aligned with the card guides may damage the backplane connector
pins inside the chassis. If there is undue resistance, remove the line
card. Check to insure that it is properly aligned with the card guides.