Filter
Top Products
48 49
WLBARGS Manual
48 49
<Windows Me/ 98/ 95>
(1) Click [Start] => Click [Run].
(2) Input [winipcfg] in the column => press [Enter].
(3) Select your network adapter to display IP address. The IP should be
192.168.1. x ,if none, please click [Release] => Click [Renew].
Q7. How to reboot the product?
A: Reboot to get new setting values applied. The steps are as follows: open the
management program-> Click on [Management]-> Click on [Proceed] in the
[Reboot] column.
*Note: The definitions of [Reboot], [Firmware update], and [Reset to default settings]
are different. Please make sure of your intention before proceeding.
Q8: How to reset to default settings?
A: If you forget the password, get failed in setting or product hang up; you can
reset the product’s settings to default values. There are 2 ways for setting:
* Use hardware
(1) Use a spindle item (e.g. a clip) to press [Init button] in the back side of the
product until [Status] lights up with red.
(2) After the red light goes out, the system will restore its default values.
* Use software
(1) Click on the [Management] function item -> click on[Back to default setting]
item from the setting page -> Click on [Proceed] to reset to default setings.