Filter
Top Products
Chapter 4: Cabling the Network Ports
86
Powering on a Switch
To power on a switch, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 45.
Figure 45. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the rear panel of
the unit (see Figure 46).
Figure 46. Connecting the AC Power Cord
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
E3
100-240VAC
~
100-240VAC
~