Altinex MT105-120/121 Switch User Manual


 
MULTI-TASKER™
400-0362-003
21
3: STATUS
Equivalent to the [C] command.
Return the card status.
4: HELP
This is equivalent to the [HELP] command.
It displays a list of commands available for
the MT105-120/121 along with a brief
description.
ESC
Return to the parent menu.
7.4.5 MENU MODE EXAMPLES
All MENU MODE examples assume an
MT105-120 is installed in slot #4. Start by
clicking the mouse in the Terminal window.
Press ENTER and a list of available cards will
be displayed.
NOTE When entering numeric values (not
selecting menu items) the system may
echo each character as it is typed. For
example, entering a delay time of 03
may appear as 0033 on the screen. This
is a property of the software being used
to control the system.
1. Connect Input 2 to Output 2
Follow the keystrokes below to connect Input 2
to Output 2.
Enter List available cards
4 Select MT105-120 in slot #4
1 Select CONTROL Menu
5 Select IN-OUT Select
2 Input 2
2 Output 2
"ok" is displayed
S New connections are displayed
ESC Return to CONTROL Menu
ESC Return to the MAIN Menu
2. Turn OFF Output 1
Starting from the main menu, turn OFF
Output 1. Follow the keystrokes below.
1 Select CONTROL Menu
4 Select ON/OFF Menu. The Output
ON/OFF statuses are displayed. The
current setting is in "( )" next to the
output number. In this case, Output 1
shows are ON.
1 Toggle Output 1 from ON to OFF.
The card will respond with the
feedback "OFF" and then "ok".
S Redisplay the status of all outputs.
ESC Return to the CONTROL Menu.
ESC Return to the MAIN Menu
3. Set Sync Delay for Output 1 to 2 seconds.
Starting from the Main Menu, set the Sync
Delay for Output 1 to 2 seconds. Follow the
keystrokes below.
2 Select SETUP Menu
3 Select SET SYNC DELAY
1 Select SDL1 (Output 1)
8 Enter 8 (x250mS)=2 sec
ESC Accept 2 sec value. Redisplay the
SDL settings for all the outputs.
ESC Return to SETUP Menu
ESC Return to the MAIN Menu
4. Add Card 4 to Group 1
Starting from the Main Menu, make the
MT105-120/121 part of Group 1. Follow the
keystrokes below.
2 Select SETUP Menu
1 Select SET GROUP ID
1 Select ASSIGN GROUP ID
1 Group 1. The card will feedback
"G1=C4".
ESC Return to Group Menu
ESC Return to SETUP menu
ESC Return to the MAIN Menu