Filter
Top Products
MULTI-TASKER™
9
INSTALLING YOUR MT107-301/305/306 6
Step 1. Locate the MT107-100 currently installed
in the Multi-Tasker™. Ensure there are
enough empty slots in the enclosure to
allow for the one or more
MT107-301/305/306's to be installed.
Step 2. Route the ribbon cables through the
notch in the add-on boards and connect
to the MT107-100 base assembly using
special high bandwidth cables provided
with the Engine. Make sure that cable
connector is secured in the socket of the
input card.
Step 3. Carefully, slide the MT107-301/305/306
into slot of the Multi-Tasker™ Enclosure.
Step 4. Secure each card by tightening the
retainer screws at the top and bottom of
each card.
OPERATION 7
7.1 RS-232 CONTROL
The MT107-301/305/306 has many advanced
remote control capabilities when used in the
Multi-Tasker™ Enclosure as part of an
MT107-100 Matrix Switcher. These capabilities
are accessible through standard RS-232
communication. The actual controlling can be
accomplished through a computer control
system or any other device capable of sending
RS-232 commands.
7.2 DESCRIPTION OF COMMANDS
Please, see the MT107-100 User's Guide for a
full listing of commands available for the
MT107 301/305/306 as part of a Multi-Tasker™
Matrix Switcher.
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied MT107-301/305/306.
However, we would like to offer suggestions for the
following:
8.1 BAD SIGNAL
Cause 1: The display is connected to the
wrong card.
Solution: Make sure the video signals are
coming from the video card (-305)
and sync signals are coming from
the sync card (-306). If the signal is
still bad, see Cause 2.
Cause 2: The switch settings are wrong.
Solution: If the output card is an MT107-301,
make sure the Video/Sync switch
settings are in the correct position
for the signal type on each channel.
If the signal is still bad, call Altinex
at (714) 990-2300.