Altinex SW1956CT Switch User Manual


 
SWITCHER
400-0378-004
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
SW1956CT Switcher. Keep this manual handy for
future reference. These safety instructions are to
ensure the long life of your SW1956CT and to
prevent fire and shock hazards. Please read them
carefully and heed all warnings.
1.1 GENERAL
Qualified ALTINEX service personnel or their
authorized representatives must perform all
service.
1.3 INSTALLATION
For best results, place the SW1956CT on a flat,
level surface. Keep in a dry area away from dust
and moisture.
To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the
SW1956CT in direct sunlight, near heaters or
heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
Handle the SW1956CT carefully. Dropping or
jarring can damage internal components.
Do not place heavy objects on top of the
SW1956CT. If the unit is to be mounted to a
table or wall, use only ALTINEX-made mounting
accessories.
To turn off the main power, be sure to remove
the cord from the power outlet. The power outlet
socket should be installed as close to the
equipment as possible, and should be easily
accessible.
Do not pull the power cord or any cable that is
attached to the SW1956CT Switcher.
If the SW1956CT is not to be used for an
extended period, disconnect the power cord
from the outlet.
1.4 CLEANING
Unplug the SW1956CT power cord before
cleaning. Clean surfaces with a dry cloth. Never
use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.5 FCC NOTICE
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.