Filter
Top Products
12 Installation
Chapter 2 - Installation
6 If the Web Configuration Server is password protected, you will be prompted to
enter your username and password in order to log in to the system. The
default username is operator and the default password is installer. See
Chapter 3 for details on using the Web Configuration Server.
7 Configure the necessary parameters according to instructions supplied by the
system administrator. The mandatory parameters that must be configured
properly are:
Enable DRAP (in BW Reservation page) only if DRAP is supported by the
wireless system (currently DRAP is supported by BreezeMAX equipment
with SW version 1.5 or higher and BreezeACCESS VL with SW version 4.0).
Uncheck if DRAP is not used.
LAN/WAN VLAN Tagged Port Membership parameters (VLAN page) and
VoIP VLAN parameters (VoIP VLAN Configuration page).
Telephony parameters (per line) in the SIP Configuration/H323 Telephone
page: Telephone Line Enable/Disable, primary SIP Server/H323 Gate
Keeper parameters, User Name and Password (SIP model), Telephone
Number, Telephone domain name (SIP model). Certain H323 Gatekeepers
require configuration of a unique H323 Alias.
WAN IP parameters (WAN Configuration page): For operation as a DHCP
client, check the Obtain WAN Configuration dynamically. For static IP
configuration, check the Specify fixed WAN configuration option and
specify the IP Address, Subnet Mask and Default Gateway.
8 Restart the unit from the Restart page.
9 If VLANs are configured for management, you will lose management from the
PC, unless the packets are tagged from the PC towards the Voice Gateway. To
resume management capabilities, return to factory defaults (see
Section 2.2.2).
10 Disconnect the PC used for configuration.
11 Use a straight Ethernet cable to connect the WAN port on the rear panel of the
unit to the Ethernet port of the SU-IDU. The length of the indoor-to-outdoor
Ethernet cable should not exceed 90 meters. The length of the Ethernet cable
connecting the indoor unit to the user's equipment, together with the length of
the Indoor-to-Outdoor cable, should not exceed 100 meters.
12 Connect the data equipment using a 10/100 Base-T Ethernet cable to the LAN
port. The length of the Ethernet cable should not exceed 100m. Use a straight
cable for connecting to a PC, or a crossed cable for connecting to a
hub/switch).