Filter
Top Products
28
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board and
you wish to use it. If you install add-on FDC or the system has no floppy drive, select Disabled in
this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and the second serial ports. The settings
are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART2 Mode
This item allows you to determine which Infrared (IR) function of the onboard I/O chip to be used.
Onboard Parallel Port
There is a built-in parallel port on the onboard Super I/O chipset providing Standard, ECP, and EPP
features. It has the following option:
Disabled
(3BCH/IRQ7)/ Line Printer port 0
(278H/IRQ5)/ Line Printer port 2
(378H/IRQ7) Line Printer port 1
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose “SPP.” To operate
the onboard parallel port in the EPP modes, choose “EPP.” By choosing “ECP”, the onboard
parallel port will operate in ECP mode only. Choosing “ECP+EPP” will allow the onboard
parallel port to support both the ECP and EPP modes simultaneously. The ECP mode requires
the use of DMA channel. So, after selecting ECP mode, the message: “ECP Mode Use DMA”
will be displayed at this time. The user can choose among DMA channels 3 to 1. The onboard
parallel port is EPP compliant. So, after you choose the onboard parallel port with the EPP
function, the message: “EPP Mode Select” will be displayed on the screen. At this time either
EPP 1.7 spec. or EPP 1.9 spec. can be chosen.
3-8 Power Management Setup
The Power Management Setup allows you to configure the system to most effective energy
saving status in a manner consistent with your own style of computer use.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Power Management Setup
Item Help
ACPI Function Enabled
ACPI Suspend Type S1(POS)
Video off Method V/H SYNC+Blank
Power Button Function Instant-Off
Wake-Up on PCI PME Disabled
Wake-Up on Ring/LAN Disabled
USB Resume from S3/S4 Disabled
Wake Up on RTC Alarm Disabled
X Time(dd:hh:mm) of Alarm 0: 0: 0
Menu Level >
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
ACPI Function