Filter
Top Products
©American Audio® - www.americanaudio.com - WM-16™ Instruction Manual Page 6
WM-16™ OPERATION
1. Plug the receiver in and press the power button on the mic located at the bottom of the mic for 2
seconds.
Note: Make sure the squelch on the receiver is turned the minimum before switching on
the power.
2. Set the receivers channel by following the dipswitch chart below. Set the mic to the same channel
as the receiver. The mic’s dipswitches are located inside the mic, in the battery compartment.
If the signal from the mic is being received by the receiver the Diversity LED’s should light up.
3. Speak, sing, or play your instrument at a typical level. The AF LED’s should icker when receiving
a signal from the microphone.
4. When nished, turn the microphone off, then unplug the receiver.
Receiver Set Up
1. Plug the included power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the power supply into an power outlet.
Note: Make sure the squelch on the receiver is turned the minimum.
Microphone Set Up
1. Unscrew the bottom part of the microphone. The battery compartment is located inside of the
microphone. Insert two AA batteries.
2. Screw the bottom of the microphone back into place.
Note: Make sure the squelch on the receiver is turned to the minimum before switching on
the power.
Connecting the Receiver Output
1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR
female connection.
2. Connect one end of the cable to the receiver, and the other end into the mic or line input of a
mixer, PA
system, or amplier. Set the Mic/Line switch accordingly on the receiver.
WM-16™ MICROPHONE SYSTEM SET UP
CH
1
CH 2 CH
3
CH
4
CH
5
CH
6
CH 7
CH
8
CH
9
CH
10
CH
11
CH 12
CH
13
CH 14 CH 15 CH 16
WM-16™ CHANNEL SETTINGS
ON