Filter
Top Products
MEGAPOWER CPU 8200-0421-02, REV. E
OPERATOR’S GUIDE
11 of 21
Function Actions
Control Auxiliary -Call camera -select auxiliary number 1–4 -press AUX ON or AUX OFF to
turn the specified auxiliary on or off
Note: Not all domes/PTZ devices support AUX4.
View Satellite Sites -Call local monitor # -enter site # -press SITE -call remote camera #
VCR Mode -Turn keyswitch to OPERATE -enter VCR # -Press VCR -Select VCR
function by pressing the appropriate key shown below:
VCR Function Icon Key Label
Stop
Off
Record
On
Pause
Close
Play
Open
Rewind
Near
Fast Forward
Far
Eject
ACK
Disconnect/Log Off
Satellite
-Press SITE -call local camera
DirectSet
(SensorNet only)
• -Press Hold only to display or close the DirectSet menu when not running a
tour or attached to an alarming monitor, or
• -Enter 0 -press Hold to display or close the DirectSet menu, or
• -Enter a number -press Hold to select a DirectSet menu command whether
or not the menu is displayed
Note:
All SpeedDome Optima camera domes can receive DirectSet commands, but do
not display the menus.
Programming Functions
Function Action
Program Presets
-Call monitor and camera -set keyswitch to PROGRAM -move camera to
position -enter Preset # -press PRESET -set keyswitch to OPERATE
Program Patterns
-Call monitor and camera -set keyswitch to PROGRAM -enter Pattern #
-press PATRN -press PROG -maneuver camera -press ACK
Clear Patterns
(RS-422 only)
-Set keyswitch to PROGRAM -enter Pattern # -press PATRN
-press CLEAR
Program Monitor Tours
-Call monitor -set keyswitch to PROGRAM -enter 62, then press PROG
-enter camera # -press CAM -enter dwell time, the press PROG
-repeat steps 4–6 until all cameras have been programmed (or the maximum count
of 64 entries is reached) -press RUN to run the Tour
Arm Monitor
-Call monitor -set keyswitch to PROGRAM
-enter arming type ID # (301–315) -press F2
Disarm Monitor -Call monitor -set keyswitch to PROGRAM -press 316, then F2
Display Current
Monitor Arming Type
-Call monitor -set keyswitch to PROGRAM -press 300, then F2