Filter
Top Products
Smart-UPS RT 15000/20000 VA 230 Vac UXI/UXICH Tower User Manual 3
Installation
Tower front panel
Install PowerView
Prior to attaching the PowerView to the UPS:
1. Loosen the two bracket screws on the back of the PowerView module.
a. Slide the bracket to the position that will accommodate the screw holes on the UPS.
b. Tighten the screws on the bracket.
2. Secure the PowerView to the UPS using the two thumb screws attached to the PowerView.
Cold Start/EPO reset
Serial Port
PowerView Cable Connector
SmartSlot with Network
Management Card
PowerView
Interface Display
Ethernet Port 10/100 Base-T
RJ45 Connector (pass through
to Rear Panel RJ45 Connector