Filter
Top Products
Smart-UPS XL 2200/3000 VA 120/230 VAC 3U Rack Mount User Manual 5
Start Up
Accessories
This UPS is equipped with an accessory SmartSlot. Refer to the APC Web site, www.apc.com for available
accessories.
If a standard accessory, such as a SNMP card is installed on this UPS, refer to the Utility CD for user
documentation.
Install accessories prior to connecting power to the UPS.
Start Up
Connect Equipment and Power to the UPS
1. The UPS features a transient voltage surge-suppression (TVSS) screw located on the rear panel, for
connecting the ground lead on surge suppression devices such as telephone and network line protectors.
Prior to connecting the grounding cable, ensure that the UPS is NOT connected to utility or battery
power.
2. Connect equipment to the UPS.
NOTE: This UPS is equiped with an external battery connector on the rear panel of the unit.
Where appropriate use an APC extension battery cable. For ordering details contact your dealer or APC
through the Web site www.apc.com.
3. Add optional accessories to the SmartSlot located on the rear panel.
4. Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.
– 230 V models: The utility power cord is supplied in the UPS literature kit. Prior to connecting the
utility power, connect the ground lead (optional) to the TVSS screw.
5. 120 V models: Check the SITE WIRING FAULT LED located on the rear panel. The LED will be
illuminated if the UPS is plugged into an improperly wired utility power outlet, (see Troubleshooting).
6. To use the UPS as a master on/off switch be sure all connected equipment is switched on.
Rear Panels
120 VAC
230 VAC