Filter
Top Products
12
Quick Configuration
continued
Configuring
TCP/IP settings,
continued
6. Enter the default user name and password: apc, both
lowercase.
7. Once the Main menu appears, choose Network.
8. From the Network menu, choose TCP/IP.
9. Within the
TCP/IP
menu:
a. Disable
BOOTP
b.Accept changes.
c. Set a valid
IP
address, Subnet Mask and default Gate-
way for your network.
d.Accept changes.
e. Press
E
SC
until the Main menu appears.
f. From the Main menu, select Logout.
Note: The new settings will not take effect until you log
out.
Over the Network by
BOOTP
.
BOOTP
is enabled by default.
Use a
BOOTP
server to configure MasterSwitch
VM TCP/IP
settings:
1. Enter the MasterSwitch
VM MAC
address,
IP
address,
Subnet Mask, default Gateway, and optional boot-up
filename.
Note: The
MAC
address can be found on the Quality
Assurance slip, on the bottom of the management
card, and on the
TCP/IP
menu from the Control
Console.
2. The
BOOTP
server will provide network settings to
MasterSwitch
VM
. If a boot-up file name was specified,
MasterSwitch
VM
will attempt to transfer that file from
a
TFTP
or
FTP
serveronthesamecomputerasthe
BOOTP
server. MasterSwitch
VM
will assume all
settings specified in the boot-up file. Otherwise,
MasterSwitch
VM
can be configured remotely using the
Telnet, Web, or
SNMP
interfaces.
Note: You must use the Management Card Wizard to
create the boot-up file.
Continued on next page