Filter
Top Products
Figure 5. Battery Installations and Connections
Battery Connections - Note: The batteries are charged and produce electric current. Small sparks by be noted during the
connection process. This is a normal condition and does not pose a threat of injury.
Connect the red battery terminal lead (protrudes from the lid) to the positive (+) terminal of the battery (Figure 5) closest to the rear
of the Main Housing Chassis (second battery installed). Connect the black battery terminal lead (protrudes from the lid) to the
negative (-) terminal of the first battery installed. Connect the black battery cable attached to the left side of the Main Housing
Chassis to the positive (+) terminal of the first battery, and to the negative (-) terminal of the second battery. Ensure battery
connections are tight by grasping each connector at the terminal and try to move it. If the terminal lead has movement on the
terminal, tighten the connection until no movement is evident. Install battery terminal covers.
Install Rear Panel - Align the Rear Panel with the mounting holes at the rear of the Main Housing Chassis. Install the four machine
screws which secure the Rear Panel to the chassis.
Install Inverter
Caution: Installation of the Power Inverter must be performed by a licensed and qualified
electrician. Failure to comply may result in equipment damage, and may also void the
Warranty.
Place the Inverter Assembly on top of the Main Housing Chassis with the Inverter facing forward, and the Inverter “feet” in the
indents provided on the Main Housing Chassis top cover.
Page 6
Main Housing Chassis
(top cover not shown)
Battery
Handle
Battery
Handle
Battery
Handle
Battery
Handle
Positive
(+)
Terminal
Negative
(-)
Terminal
Second Battery
(rotated 180 degrees)
First
Battery
Main Housing Chassis
(top cover shown)
Red (+)
Wire
Black
Wire
Black
(-)
Wire
Battery Installation Battery Connections
Positive (+)
Terminal
Negative (-)
Terminal
Negative
(-)
Terminal
Positive
(+)
Terminal
Main Housing Chassis
(rotated 180 degrees)