Filter
Top Products
Menu System
22
5200 User’s Manual
Source Command - Is used to select the desired input or display mode. With all available
options installed, the user may select between two (2) RGB modes, two (2) Video modes and
the internal graphics mode.
RGB-1
The RGB-1 input includes separate connectors for RED, GREEN, BLUE video signals, plus
separate connectors for Composite Sync (Horizontal Drive in the case of five (5) wire inputs)
and Vertical Drive.
The Analog RGB input falls into three major categories, three-wire with sync-on-green, four-
wire with composite sync and five-wire with separate horizontal and vertical drives. The
AmPro 5200 will automatically configure itself properly for any of the above conditions,
including sync input and polarity.
RGB-2
An HD15-pin connector is provided for direct connection to a VGA/SVGA and XGA from an
external PC.
Video
(optional)
he Video input is provided through either the internal Faroudja Decoder or the internal AmPro
quad video decoder. The AmPro quad decoder will automatically works with Composite
NTSC, NTSC 4.43, PAL or SECAM.
S-Video
(optional)
A secondary input to either the above mentioned decoders is the S-Video input. This input
uses a 4-pin mini Din connector, which is standard for this input.
Internal
Refers to the internal graphics card and Windows 95® operation. When no external source is
available or required, switch to the internal mode of operation
Configure
Search
The configure search command enables a check box dialog window (left) where you have
the option of selecting which source the projector will search if no signal is applied or a lost of
signal occurs.