Filter
Top Products
6 - 3402230800/AC
The card is configured by default with this service enabled. No manual configuration is required.The IP
parameters are automatically collected by the card.
From the main configuration menu: (see above)
◗
Press the 2 key (Network configuration).
◗
Press the 1 key(Read Network settings).
The settings supplied by the server are displayed:
◗
Note the IP address.
◗
Press the 0 key (Exit).
◗
Press the 0 key (Exit).
You can also use MUPGRADE software utility to view the card IP adress
Provided on the Solution-Pac 2 CD-ROM or at www.mgeups.com. It must be installed on a network connected
PC.
Manual configuration is required.
To set the network configuration, use terminal emulation (see above)
From the main configuration menu:
◗
Press the 2 key (Network configuration).
◗
Press the 2 key (Modify Network settings).
◗
Follow the instructions and enter the IP parameters:
Wait until "Done" is displayed, indicating that the IP parameters have been saved.
◗
Press the 0 key (Exit).
◗
Press the 1 key (Reset).
◗
Press the 2 key (Restart).
The card restarts with the new IP settings (after approx. one minute).
Your network is equipped with a BOOTP/DHCP server (default)
Network configuration :
MAC address : 00:06:23:00:1C:07
Mode : DHCP
IP address : 172.17.23.18
Subnet mask : 255.255.248.0
Gateway : 172.17.17
Your network is not equipped with a BOOTP/DHCP server
1 : Read Network settings
2 : Modify Network settings
3 : Set ethernet speed
0 : Exit
For each of the following questions, you can press "Return" to select
the value shown in braces, or you can enter a new value
Should this target obtain IP settings from the network?[N] N
Static IP address [172.17.16.16]?172.16.1.82
Subnet mask IP address [255.255.0.0]? 255.255.255.0
Gateway address IP address [0.0.0.0]? 172.17.17.1
Done