Filter
Top Products
6
UPS Installation, continued
Step 3:Install
the Web/SNMP
Management
Card
Caution:
If you are installing the Management Card in a
Symmetra
Power Array
that uses more than one APC
management peripheral, see the supplied
Installation
of Multiple SmartSlot Cards
sheet. You must install
the APC peripherals in the correct order, otherwise
the peripherals may fail to operate properly.
1. Use the screws that hold the slot cover in place to secure
the Management Card in the UPS expansion slot.
2. Connect a network interface cable to the 10Base-T net-
work connector on the Management Card.
3. If neccessary, reconnect the PowerChute
plus
cable.
4. Reconnect the UPS to its input power source.
5. Turn on the UPS.
6. If neccessary, restart the PowerChute
plus
service.
7. See “Quick Configuration” on page 9.
Figure 1: Connecting a Management Card in a Smart-UPS
Link - RX/TX
Status
10Base-T
Reset
Smart Slot
AP9606 Web/SNMP Management Card