Filter
Top Products
UPS Network Management Card 2 User’s Guide30
Monitor and Configure the UPS
Note: For an AP9631 Network Management Card with a connected APC Dry Contact I/O
Accessory (AP9810), the UPS tab displays two top menu bar options, UPS and Control
Policy. Use the UPS option to complete the tasks described in this chapter.
For information about the Control Policy option, see “Configuring the Control Policy” on
page 50.
Overview Page
The Overview page is displayed by default when you click the UPS tab or when you select the UPS tab
and then Overview on the left navigation menu of that tab.
Operating state
Below the UPS model name and configured UPS name, icons and accompanying text indicate the
operating status of the UPS:
Quick Status
The following information is displayed (some fields are model-specific and may not display for your
UPS).
• In graphs:
– Load in Watts: A graph showing the load of the attached equipment as a percentage of
available Watts.
– Battery Capacity: A graph showing the percentage of the total UPS battery capacity available
to support attached equipment.
Operating State Icon Description
Online
No Alarms: No alarms are present, and the UPS and Management
Card are operating normally.
In an alarm state
(Accompanying text
names the alarm
condition and gives a
brief description of
the alarm.)
Critical: A critical alarm exists, which requires immediate action to
avoid data loss or equipment damage.
Warning: An alarm condition requires attention and could
jeopardize your data or equipment if its cause is not addressed.