Filter
Top Products
Basics Resetting the Logic Board - 18
5 Verify the power supply cable is disconnected from the
logic board and then press the Power On button. (See
"Logic Board Diagram" later in this chapter to locate the
Power On button.)
6 Wait at least 10 minutes before replacing the battery.
Make sure the battery is installed in the correct +/-
direction.
7 Reassemble the computer and test the unit.
Note:
This procedure resets the computer’s PRAM. Be sure
to check the computer’s time/date and other system
parameter settings afterwards.
Note:
If this procedure resolves the problem, claim an
adjustment on an SRO. If not, replace the defective
component and DO NOT claim the adjustment procedure.