Filter
Top Products
29
For calls that are automatically generated, a total of three call attempts are allowed to a telephone number, with a
minimum period between calls of 2 seconds. If the call does not connect after three attempts, 30 minutes must
expire before automatic redialing may be initiated. Failure to set the modem (and any associated communications
software) to the above settings may result in the modem being non-compliant with Australian
telecommunications standards. Under these circumstances a user could be subject to significant penalties under
the Telecommunications Act 1997.
Information You Need in New Zealand
This modem is fully approved to operate on the New Zealand telecommunications network under Telepermit
number PTC 211/98/119. All telecommunications devices are required to hold a Telepermit and be labelled
accordingly with the approved Telepermit number to comply with the New Zealand telecommunications
standards, ensuring the health and safety of the operator and the integrity of the New Zealand
telecommunications network.
Note: Customers in New Zealand who are prompted to choose a country for their modem should choose the
“Australia” country code setting.
To ensure compliance, all calls that are automatically generated should not make more than 10 call attempts to
the same number within any 30 minute period with a minimum period between calls of 30 seconds. Failure to
adhere to these standards may result in the modem being non-compliant with New Zealand Telecom standards.
Under these circumstances a user could be subject to significant penalties.
Important If pulse dialing is required for any reason, the communications software must be set up to record
numbers according to the following translation list.
m Number to be dialed: 0; number to be entered into computer: 0
m Number to be dialed: 1; number to be entered into computer: 9
m Number to be dialed: 2; number to be entered into computer: 8
m Number to be dialed: 3; number to be entered into computer: 7
m Number to be dialed: 4; number to be entered into computer: 6
m Number to be dialed: 5; number to be entered into computer: 5
m Number to be dialed: 6; number to be entered into computer: 4
m Number to be dialed: 7; number to be entered into computer: 3
m Number to be dialed: 8; number to be entered into computer: 2
m Number to be dialed: 9; number to be entered into computer: 1
The preferred method of dialing is to use DTMF tones as this is faster than pulse (decadic) dialing and is readily
available on almost all New Zealand telephone exchanges.
Warning This card must be properly secured in order for you to use it. Telecommunications network voltages
exist inside the computer and the telecommunications line connection must be removed before opening the
computer.