Filter
Top Products
11.4 Interface Config mode commands
11.4.1 exit command
Exit current shell
Format exit
Mode Interface Config
11.4.2 dot1x command
Set 802.1x port control.
11.4.2.1 Set auto-authorized on ports
Format 802.1x port-control {enable|disable}
Mode Interface Config
11.4.3 Configure port lacp mode
11.4.3.1 admin command
Configure admin key of port
Format lacp admin <0 ..65535>
Mode Interface Config
e.g. switch(interface g1)#lacp admin 36768
11.4.3.2 priority command
Configure lacp port priority
Format lacp priority <0..65535>
Mode Interface Config
11.4.4 addport command
add one port to a LAG group
Format addport <LAG-ID>
Mode Interface Config
11.4.5 delport command
Remove a port from a LAG group
Format delport <LAG-ID>
Mode Interface Config
11.4.6 lldp command
An lldp agent can transmit information about the capabilities and current status
of the system associated with its MSAP identifier. The lldp agent can also
receive information about the capabilities and current status of the system
associated with a remote MSAP identifier. However, lldp agents are not
provided any means of soliciting information from other lldp agents via this
protocol.
11.4.6.1 lldp state set
lldp status
Only transmit the lldp status
Format lldp state {tx|rx| tx_rx|disable}
Mode Interface Config
11.4.6.2 configure notifications
Enable/disable notification form the agent
Format lldp notification {enable|disable}
Mode Interface Config
11.4.6.3 Configure med notifications
Configure wether or not MED notifications from the agent are enabled.
Enable/disable med notification form the agent
Format lldp med-notification {enable|disable}
Mode Interface Config
e.g. Switch(Interface 1)#lldp med-notification enable
11.4.6.4 Configures which TLVs are enabled for
transmission.
1) basic set
Format lldp tlvs-tx {enable|disable} option basic
143 Asante IC3724PWR User’s Manual