Filter
Top Products
Asanté FriendlyNET FX4000 8
FX40-8TP Module
When installed into the switch, this module provides 8 x 10/100 Mbps ports that can connect the switch to a
10 or 100 Mbps hub or end station. It utilizes 3 LED's to indicate status: 100M, Link/Activity and Full
Duplex/Collision.
FX40-2SMC15 Fiber Module
When installed into the switch, this module provides 2 x 100BaseFX fiber ports that can be used to connect
the switch to the backbone of the network, to a 100 Mbps server or end station.
A SC connector provides the link to the multi mode cabling and there are 2 LED indicators to show the
following status: Link/Activity and Full Duplex. A DIP switch, located on the module board, sets the operating
mode to half or full duplex (full duplex is the default).
The following table lists the ports’ operating modes based on the DIP switch position.
Port 1 Port 2
SW 1 2
ON Half Duplex Half Duplex
OFF Full Duplex Full Duplex