Filter
Top Products
10
Getting Started Guide
•
Do not tamper with the internal components of your switch.
This could void your warranty
•
Examine your work area for potential hazards (I.e. wet floors,
ungrounded cables, etc.) and eliminate them before installing
your switch
For more safety information, please refer to the User’s Manual.
2.2 Recommended Installation Tools
You will need the following tools and equip-
ment (not included) to install the switch:
•
Number 1 Phillips screwdriver
•
Number 2 Phillips screwdriver
•
3/16-inch flat-blade screwdriver
•
Antistatic mat or foam
•
An ESD grounding strap
2.3 Power Requirements
The electrical outlet should be located near the switch and be easily
accessible. It must also be properly grounded.
Make sure the power source adheres to the following guidelines:
•
Power: Auto Switching 110/240 VAC
•
Frequency range: 50/60 Hz
•
Maximum input AC Current: 1.0A at 115 VAC full load
2.4 Environmental Requirements
The switch must be installed in a clean, dry, dust-free area
with adequate air circulation to maintain the following environ-
mental limits:
•
Operating Temperature: 0° to 40° C (32° to 104° F)
•
Storage Temperature: -20° to 70° C (-4° to 158° F)
•
Relative Humidity: 10% to 90% relative humidity
•
Storage Relative Humidity: 10% to 95% relative humidity