Filter
Top Products
30 Chapter 2
Security
The Security screen contains parameters that help safeguard and protect your computer from unauthorized
use.
NOTE: Please refer to “Remove HDD/BIOS Password” section if you need to know how to remove HDD/BIOS
Password.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter Description Option
Supervisor Password Is Shows the setting of the Supervisor password
Clear or Set
User Password Is Shows the setting of the user password.
Clear or Set
HDD Password Is Shows the setting of the hard disk password.
Clear or Set
Set Supervisor Password Press Enter to set the supervisor password.
When set, this password protects the BIOS
Setup Utility from unauthorized access. The
user can not either enter the Setup menu nor
change the value of parameters.
Set User Password Press Enter to set the user password. When
user password is set, this password protects
the BIOS Setup Utility from unauthorized
access. The user can enter Setup menu only
and does not have right to change the value of
parameters.
Set HDD Password Enter HDD Password.
Password on Boot Defines whether a password is required or not
while the events defined in this group
happened. The following sub-options are all
requires the Supervisor password for changes
and should be grayed out if the user password
was used to enter setup.
Disabled or Enabled
Item Specific Help
Install or Change the
passeord and the length
of password must be
greater than one word.
Supervisor Password Is
User Password Is
HDD Password
Set User Password
Power on password
Set Supervisor Password
Set Hdd Password
Clear
Clear
Clear
[Disabled]
InsydeH20 Setup Utility
Main
Information Security
Boot Exit
Rev. 3.5
F1
Esc
Help
Exit
Select Item
Select Menu
Change Values
Select►Sub-Menu
F5/F6
Enter
F9
F10
Setup Default
Save and Exit