Filter
Top Products
Chapter 2 36
Switch Function
This option enables you to specify the function of
the button:
1. Disabled: The button functions is disabled
2. Break/Wake: The button functions are same as
suspend button in APM mode. When the button is
depressed, the system enters a suspended state until
the button is again depressed to return the system to
normal operating status.
Disabled
Break/Wake
Mode Use IRQ If you want an incoming call on a modem to
automatically resume the system from a power-
saving mode, use this item to specify the interrupt
request line (IRQ) that is used by the modem. You
might have to connect the fax/modem to the
mainboard Wake On Modem connector for this
feature to work.
N/A
3
4
5
7
9
10
11
Hot Key Function As This option allows you to set the Hot Key
functionality to one of the following states:
Disabled, Power Off and Suspend
Disabled
Power Off
Suspend
HDD Power Down This option lets you specify the IDE HDD idle time
before the device enters the power down state. This
item is independent from the power states previously
described in this section (Standby and Suspend).
Disabled
1~15 Mins
Soft-off by PWR-BTTN This is a specification of ACPI and supported by
hardware. When Delay 4 sec. is selected, the soft
power switch on the front panel can be used to
control power On, Suspend and Off.The other setting
is Instant-Off, where the soft power switch is only
used to control On and Off, there is no need to press
4 sec, and there is no Suspend.
Instant Off
Delay 4 Sec
After AC Power Lose This item specifies when your system reboot after a
power failure or interrupt occurs.
Always Off
Always On
Former-Sts
PM Wake Up Events Disabled: The specified event's activity will not affect
the PM Timers/wake up the system.
Enabled: The specified event's activity will affect the
PM Timers/wake up the system.
For example, if you have a modem on IRQ3, you can
turn On IRQ3 as a wake-up event, so an interrupt
from the modem can wake up the system. Or you
may wish to turn Off IRQ12 (the PS/2) mouse as a
wake-up event, so accidentally brushing the mouse
does not awaken the system.
Press Enter
Parameter Description Option