Filter
Top Products
ASUS A7N8X-VM motherboard user manual
1-5
Onboard LED. This onboard LED lights up if there is a standby power on
the motherboard. This LED acts as a reminder to turn off the system power
before plugging or unplugging devices.
ATX power connector. This standard 20-pin connector connects to an
ATX 12V power supply. The power supply must have at least 1A on the
+5V standby lead (+5VSB).
CPU Socket. Socket 462 (Socket A) Zero Insertion Force (ZIF) socket for
AMD Athlon XP™ up to 3000+ processors.
NorthBridge Controller. The NVIDIA
®
nForce2™ IGP North Bridge
controller chipset. The controller supports a 64/128bit DDR memory
controller and up to 2 GB of 400/333/266/200MHz DDR memory. The
Northbridge controller is equipped with a maximum 128MB integrated
graphics UMA share memory for the onboard VGA.
DDR DIMM Sockets. Equipped with two Double Data Rate Dual Inline
Memory Module (DDR DIMM) sockets to support up to 2GB of DDR
SDRAM, the newest memory standard with the highest bandwidth and
lowest latency currently available. This memory technology supplies data
transfer rates up to 6.4GB/s for 400MHz DDR SDRAM.
IDE Connectors. These dual-channel bus master IDE connectors support
up to four UltraDMA133/100, PIO Modes 0-4 IDE devices. Both the
primary(blue) and secondary(black) connectors are slotted to prevent
incorrect insertion of the IDE ribbon cable.
Floppy Disk connector. This connector connects the provided ribbon
cable for the floppy disk drive. One side of the connector is slotted to
prevent incorrect insertion of the floppy disk cable.
Flash ROM. This 4Mb ISA chip contains the programmable BIOS program.
Super I/O chipset. ITE IT8712F-A offers support for a variety of I/O
functions. Provides two high-speed UART compatible serial ports and one
parallel port with EPP and ECP capabilities. The Super I/O controller
supports a floppy disk drive, PS/2 keyboard, and PS/2 mouse.
South bridge controller. This motherboard is loaded with the brand new
NVIDIA
®
nForce2™ MCP integrated peripheral South Bridge controller
which operates at 800MB/s to communicate with the North Bridge for
maximum bandwith required for PCI, USB and support for Fast Ethernet
devices. The controller supports standard UltraDMA133/100 and separate
data paths for each IDE channel are built-in for up to two IDE devices. The
controller supports six USB ports, one LAN port and is PCI rev2.2
compliant.
1
2
3
4
5
6
7
8
9
10