Asus A7V133 Computer Hardware User Manual


 
ASUS A7V133 Users Manual
3. HARDWARE SETUP
3.5 System Memory (DIMM)
This motherboard uses only Dual Inline Memory Modules (DIMMs). Three sockets
are available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random
Access Memory (SDRAM) of 8, 16, 32, 64, 128, 256, or 512MB to form a memory
size between 8MB to 1.5GB. One side (with memory chips) of the DIMM takes up
one row on the motherboard. This motherboard also supports NECs Virtual Channel
(VC) SDRAMs. Memory speed setup is recommended through BIOS SDRAM Con-
figuration under Chipset Features Setup.
IMPORTANT (see General DIMM Notes below for more):
SDRAMs used must be compatible with the current Intel PC133
SDRAM specification.
DO NOT attempt to mix PC133 SDRAMs with VCM SDRAMs.
The motherboard only supports PC100 / PC133 DIMMs or VC
SDRAMs for system memory. Registered DIMMs are not supported.
System Memory
3. H/W SETUP
Install memory in any combination as follows:
DIMM Location 168-pin DIMM Total Memory
Socket 1 (Rows 0&1) SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Socket 2 (Rows 2&3) SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Socket 3 (Rows 4&5) SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Total System Memory (Max 1536MB) =
3.5.1 General DIMM Notes
DIMMs that have more than 18 chips are not supported on this motherboard.
For the system CPU bus to operate at 100MHz/133MHz, use only PC100-/PC133-
compliant DIMMs.
ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the
memory of choice for best performance vs. stability.
SDRAM chips are generally thinner with higher pin density than EDO (Extended
Data Output) chips.
BIOS shows SDRAM memory on bootup screen.
Single-sided DIMMs come in 16, 32, 64,128, 256MB; double-sided come in 32, 64,
128, 256, 512MB.
WARNING! Be sure that the DIMM you use can handle the specified SDRAM
MHz or else bootup will not be possible.