Asus A7V266-M Computer Hardware User Manual


 
ASUS A7V266-M motherboard user guide
29
®
A7V266-M
A7V266-M IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Primary IDE Connector
Secondary IDE Connector
PIN 1
10)Primary (Blue) / Secondary (Black) IDE Connectors
(40-1 pin PRIMARY IDE and SECONDARY IDE)
These connectors support the IDE hard disk ribbon cables supplied with the
motherboard. Connect the cables blue connector to the motherboards
primary IDE connector (recommended) or the secondary IDE connector. Then
connect the opposite end of the cable to your hard disk. A second slave hard
disk may be attached to the intermediate connector on the cable; it may be
necessary to reset its jumper to Slave mode. Refer to your hard disk
documentation for the jumper settings. It is recommended that non-ATA-
100/66 devices be connected to the secondary IDE connector. BIOS now
supports specific device bootup (see 4.6 Boot Menu.)
NOTE: ATA-100 is backward compatible with ATA-66 and ATA-33 as with
all existing ATA devices and systems; there is no need to upgrade current
EIDE/IDE drives and host systems. ATA-66 and ATA-100 IDE devices
require a 40-pin 80-conductor cable and RAID arrays only operate with
such cables.