Filter
Top Products
ASUS AK35 chassis kit
2-15
4. Prepare hard disk drive.
Carefully connect the SCSI-IDE
HDD bridge board to the 40-1
pin IDE connector and 4-pin
power connector. Make sure
that the SCSI-IDE HDD bridge
is properly connected.
5. Carefully place the hard disk
drive into the drive tray. Align
the four (4) screw holes on the
drive with those on the tray
rails. Secure drive with four
round head screws.
6. Secure the SCSI-IDE HDD
Bridge to the tray with two (2)
round head screws.
7. Re-attach the rear bracket and
secure it with two (2) flat head
screws.
Do not overtighten the screws to avoid breaking the plastic tray rails.
SCSI-IDE HDD bridge board
4
5
6
7
8. To install the tray into the bay, follow steps 5, 6, and 7 in section 2.5.1.