Filter
Top Products
Chapter 2: Hardware setup
2-20
2.7 Removable components
When installing or removing system devices, you may need to remove
previously installed components. This section describes how to remove
these components.
2.7.1 HDD blower
To remove the HDD blower:
1. Disconnect the 3-pin HDD blower cable from the FAN 1 connector on
the SCSI backplane.
2. Press the tab at the bottom of
the blower to release it from the
chassis.
3. Pull out the HDD blower.
HDD blower
Blower tab
2
3
HDD blower cable
1
HDD blower