Filter
Top Products
1-11 Chapter 1: Product introduction
1. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the
Serial ATA 1.5Gb/s specication. The data transfer rate of the Serial ATA 3Gb/s is faster
than the standard parallel ATA (133 MB/s).
SATA1
GND
RSATA_RXN1
RSATA_RXP1
GND
RSATA_TXN1
RSATA_TXP1
GND
SATA2
GND
RSATA_RXN2
RSATA_RXP2
GND
RSATA_TXN2
RSATA_TXP2
GND
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
AT3IONT-I DELUXE
AT3IONT-I SERIES SATA connectors
• Install the Windows
®
XP Service Pack 2 or later versions before using Serial ATA.
• If you intend to create a Serial ATA RAID set using these connectors, set the SATA
Mode Select item in the BIOS to [RAID Mode]. See 2.3.4 Storage Conguration for
details.
• The motherboard does not provide a oppy disk drive connector. You could use a USB
oppy disk drive when installing Windows
®
XP operating system on a hard disk drive
that includes a RAID/AHCI set.
• Due to Windows
®
XP limitation, Windows
®
XP may not recognize the USB oppy disk
drive.
• The motherboard does not support installing Windows
®
XP OS with SATA ODD under
RAID/AHCI mode.
• You need to copy RAID driver to other media such as a USB ash disk and load RAID
driver during installing Windows
®
Vista OS with SATA ODD.
• For more details on RAID/AHCI, refer to the RAID/AHCI Supplementary Guide included
in the folder named Manual in the support DVD.
1.7.2 Internal connectors