Filter
Top Products
54
LED projector E-Manual
DRAFT 2 12/17/12
DRAFT 2 12/17/12
DRAFT 2 12/17/12
Using Display by Client mode
1. Connect the Wi-Fi dongle to your LED projector to launch the
Media Center.
NOTE: If the Media Center does not automatically launch, press
then select EZLINK-WIFI
2. Select Display by Client mode.
3. Press to scroll up or to scroll down the list of available
Wi-Fi hotspots then press to select the Wi-Fi hotspot you
would like to connect to.
4. Press to launch the onscreen display menu’s keyboard.
Refer to the control panel grid when navigating the keyboard to
input the Wi-Fi hotspot’s password.
5. Press OK to start the Wi-Fi connection between the Wi-Fi
hotspot and your LED projector.
6. Repeat the same steps under Using Display by AP mode to
connect input devices to the LED projector.