Asus CUW-RM Computer Hardware User Manual


 
34 ASUS CUW-RM Users Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
9) Primary / Secondary IDE Connectors (40-1 pin PRIMARY/SECONDARY)
These connectors support the provided UltraDMA/66 IDE hard disk ribbon cable.
Connect the cables blue connector to the motherboards primary (recommended)
or secondary IDE connector, and then connect the gray connector to your
UltraDMA/66 slave device (hard disk drive) and the black connector to your
UltraDMA/66 master device. It is recommended that non-UltraDMA/66 devices
be connected to the secondary IDE connector. If you install two hard disks, you
must configure the second drive to Slave mode by setting its jumper accord-
ingly. Refer to your hard disk documentation for the jumper settings. BIOS now
supports specific device bootup (see Boot Sequence in 4.6 Boot Menu). (Pin
20 is removed to prevent inserting in the wrong orientation when using
ribbon cables with pin 20 plugged). If you have more than two UltraDMA/66
devices, you will need to purchase another UltraDMA/66 cable.
NOTE: A small hole near the blue connector on the UltraDMA/66 cable is in-
tentional.
TIP: You may configure two hard disks to be both Masters with two ribbon
cables one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through Boot Sequence in 4.6 Boot Menu.
IMPORTANT: UltraDMA/66 IDE devices must use an 80 pin IDE cable.
®
CUW-RM
CUW-RM IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1
Secondary IDE Connector
Primary IDE Connector
PIN 1
10) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
CUW-RM Floppy Disk Drive Connector
PIN 1
®
CUW-RM