SATA Mode Selection [AHCI]
Allows you to set the SATA conguration.
[Disabled] Disables the SATA function.
[IDE] Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
[RAID] Set to [RAID Mode] when you want to create a RAID conguration from the
SATA hard disk drives.
The following item appears only when you set the SATA Mode Selection to [RAID].
Pcie Nand Configuration [Auto]
This item allows you to enable or disable PCIe NAND. Conguration options: [Auto]
[Disabled] [Enabled]
Aggressive LPM Support [Disabled]
This item is designed for LPM (link power management) support with a better energy saving
conditions. When disabled, the hot plug function of SATA ports are disabled. Conguration
options: [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T. (Self‑Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power‑on Self Test) when an error occurs in the
hard disks. Conguration options: [On] [Off]
Hot Plug [Disabled] (SATA6G_1 - SATA6G_6)
These items allow you to enable/disable SATA Hot Plug Support. Conguration options:
[Disabled] [Enabled]
2.6.4 System Agent Configuration
CPU Display Audio [Enabled]
Enable this item to support CPU display audio output. Conguration options: [Enabled]
[Disabled]
DVI Port Audio [Off]
Enable this item to support audio output for certain DVI monitors. Conguration options: [On]
[Off]
Graphics Configuration
Allows you to select a primary display from CPU, PCIE and PCI graphical devices.
Primary Display [Auto]
Allows you to select the primary display from CPU, PCIE and PCI graphics devices.
Conguration options: [Auto] [CPU Graphics] [PCIE] [PCI]
ASUS H97-PLUS 2‑33