Asus P5NSLI/WIFI Computer Hardware User Manual


 
1-26 Chapter 1: Product introduction
2. USB device wake-up (3-pin USBPW1, USBPW2)
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh,
power supply in reduced power mode).
The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise,
the system would not power up.
The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
3. Keyboard power (3-pin KBPWR)
This jumper allows you to enable or disable the keyboard wake-up
feature. Set this jumper to pins 2-3 (+5VSB) to wake up the computer
when you press a key on the keyboard (the default is the Space Bar).
This feature requires an ATX power supply that can supply at least 1A
on the +5VSB lead, and a corresponding setting in the BIOS.
(Default)
+5V
+5VSB
KBPWR
1
2
3
2
P5NSLI Keyboard Power Setting
R
3
2
2
1
+5V
(Default)
+5VSB
USBPW1
+5V
(Default)
+5VSB
USBPW2
3
2
2
1
P5NSLI USB Device Wake Up
R