Asus P5NT WS Computer Hardware User Manual


 
ASUS P5NT WS 5-33
If you want to boot the system from a hard disk drive included in a RAID set,
rst copy the RAID driver from the Support DVD to a oppy disk before you
install an operating system to a selected hard disk drive. Refer to section “5.5
Creating a RAID driver disk” for details.
Setting the BIOS RAID items
After installing the hard disk drives, make sure to set the necessary RAID items in
the BIOS before setting your RAID conguration.
To set the BIOS RAID items:
1. Boot the system and press <Del> during the Power-On Self-Test (POST) to
enter the BIOS Setup Utility.
2. Enable the RAID Enabled item in the BIOS. See section “4.4.6 Onboard
Device Conguration > Serial-ATA Conguration” for details.
3. Select and enable the IDE or SATA drive(s) that you want to congure
as RAID. See section “4.4.6 Onboard Device Conguration > Serial-ATA
Conguration” for details.
4. Save your changes and Exit Setup.
5.4.2 NVIDIA
®
RAID congurations
The motherboard includes a high performance SATA RAID controller integrated in
the NVIDIA
®
chipset. It supports RAID 0, RAID 1, RAID 0+1, RAID 5 and JBOD for
six independent Serial ATA channels.
Installing Serial ATA (SATA) hard disks
The motherboard supports Ultra DMA 133/100/66 and Serial ATA hard disk drives.
For optimal performance, install identical drives of the same model and capacity
when creating a disk array.
To install the SATA hard disks for a RAID conguration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
Refer to the RAID controllers user manual in the motherboard support DVD
for detailed information on RAID congurations. See section “5.2.5 Manuals
menu.”