Filter
Top Products
1-34
Chapter 1: Product introduction
10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either High Denition Audio or legacy AC ‘97 audio standard.
Connect one end of the front panel audio I/O module cable to this connector.
• Use a chassis that provides a high-denition audio front panel audio I/O to
use the high-denition audio features.
• By default, this connector is set to [AC97]. If you want to connect a High-
Denition front panel audio module to this connector, set the Front Panel
Support Type item in the BIOS Setup to [HD Audio]. See page 2-25 for
details.
®
P5VD2-X
P5VD2-X Analog front panel connector
AAFP
Legacy AC’97-compliant
pin definition
NC
MIC2
Line out_R
Line out_L
NC
NC
MICPWR
NC
AGND
PORT1 R
SENSE2_RETUR
PORT1 L
PORT2 R
PORT2 L
SENSE1_RETUR
SENSE_SEND
PRESENCE#
GND
Azalia-compliant
pin definition
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
®
P5VD2-X
P5VD2-X Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)