Filter
Top Products
ASUS P5WDG2-WSASUS P5WDG2-WS
ASUS P5WDG2-WSASUS P5WDG2-WS
ASUS P5WDG2-WS
2-352-35
2-352-35
2-35
•
These connectors are set to
Standard IDE Standard IDE
Standard IDE Standard IDE
Standard IDE mode by default. In
SS
SS
S
tandard IDE tandard IDE
tandard IDE tandard IDE
tandard IDE mode, you can connect Serial ATA boot/data hard
disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the
Configure SATA AsConfigure SATA As
Configure SATA AsConfigure SATA As
Configure SATA As
item in the BIOS to [RAID]. See section “4.3.6 IDE Configuration” for
details.
•
For RAID 5, use at least three hard disk drives. For RAID 10, use at
least four hard disk drives. Use two to four Serial ATA hard disk
drives for each RAID 0 or RAID 1 set.
3.3.
3.3.
3.
ICH7R Serial ATA connectors (7-pin SATA1 [red],ICH7R Serial ATA connectors (7-pin SATA1 [red],
ICH7R Serial ATA connectors (7-pin SATA1 [red],ICH7R Serial ATA connectors (7-pin SATA1 [red],
ICH7R Serial ATA connectors (7-pin SATA1 [red],
SATA2 [red], SATA3 [black], SATA4 [black])SATA2 [red], SATA3 [black], SATA4 [black])
SATA2 [red], SATA3 [black], SATA4 [black])SATA2 [red], SATA3 [black], SATA4 [black])
SATA2 [red], SATA3 [black], SATA4 [black])
These connectors are for Serial ATA signal cables for Serial ATA hard
disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 10, and RAID 5 configuration with the Intel
®
Matrix
Storage Technology through the onboard Intel
®
ICH7R RAID controller.
P5WDG2-WS
®
P5WDG2-WS IDE connector
NOTE: Orient the red marking
s
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
P5WDG2-WS
®
P5WDG2-WS SATA connectors
SATA1
SATA4 SATA3
SATA2
GND
SATA_RXP0
SATA_RXN0
GND
SATA_TXN0
SATA_TXP0
GND
GND
SATA_RXP1
SATA_RXN1
GND
SATA_TXN1
SATA_TXP1
GND
GND
SATA_RXP2
SATA_RXN2
GND
SATA_TXN2
SATA_TXP2
GND
GND
SATA_RXP3
SATA_RXN3
GND
SATA_TXN3
SATA_TXP3
GND