Filter
Top Products
ASUS P/I-P55TVP4 User's Manual 11
III. INSTALLATION
2. System Memory (DRAM/SDRAM & SRAM)
This motherboard supports four 72-pin SIMMs (Single Inline Memory Modules) of
4MB, 8MB, 16MB, or 32MB to form a memory size between 8MB to 128MB. The
DRAM can be either 60ns or 70ns Fast Page Mode (Asymmetric or Symmetric) or
EDO. SIMMs must be installed in pairs so that each bank contains two of the same
size memory modules. A new feature is the support of Dual Inline Memory Mod-
ules (DIMM). One slot is available for a 3.3Volt Unbuffered Synchronous DRAM
(SDRAM) of either 8, 16, or 32MB. Maximum memory of SIMM + DIMM is 128MB.
IMPORTANT: Memory speed setup is required in BIOS Chipset Setup "Auto
Configuration."
Install memory in any or all of the banks in any combination as follows:
Bank Memory Module Total Memory
Bank 0 4MB, 8MB, 16MB, 32MB x2
SIMM Slots 1&2 72-pin FPM or EDO SIMM
(Single or Double sided)
Bank 1 4MB, 8MB, 16MB, 32MB x2
SIMM Slots 3&4 72-pin FPM or EDO SIMM
(Single sided; or Double but
Bank 2 must be empty)
Bank 2 8MB, 16MB, 32MB, 64MB x1
DIMM Slot 1 168-pin Synchronous DIMM
(Single sided; or Double but
Bank 1 must be empty)
Total System Memory (Max 128MB) =
WARNING: Memory Bank 0 & 1's signal level (not power level) is 5 volts.
Memory Bank 2's signal level may be 3.3 volts or 5 volts depending on the
SDRAM manufacturer. The SDRAM that you install in the Bank 2 DIMM
slot must have 5 volt signal level tolerance when Bank 1 and/or Bank 2 is
filled or you may cause damage to the SDRAM.
IMPORTANT: Each bank must have the same size memory installed in pairs.
Bank 0 can use either Single or Double sided memory modules, independent of
Banks 1 & 2. Banks 1&2 are related and combined can only have two sides,
either 2 Single sided or 1 Double sided memory module. Do not use memory
modules with more than 24 chips per module. Modules with more than 24
chips exceed the design specifications of the memory subsystem and will be
unstable.
(System Memory)
III. INSTALLATION
Related