Filter
Top Products
Chapter 2. Hardware Setup
13
Installation
Grounding
To prevent damage to your installation it is important that all devices are
properly grounded.
1. Use a grounding wire to ground both units by connecting one end of the
wire to the grounding terminal, and the other end of the wire to a suitable
grounded object.
Note: The grounding wire is not included in the package. Please contact your
dealer for the appropriate cable.
2. Make sure that the computer that the CE774L / CE775L connects to and
the monitor that the CE774R / CE775R connects to are properly grounded.
3. For increased grounding protection, use STP (shielded twisted pair) cable
to connect the Local and Remote Units. There are two methods that can be
used:
a) In addition to the eight paired wires, STP cable also contains a
grounding wire. Solder this wire to the RJ-45 connector as shown in the
diagram below:
STP Cable
(Cat 5e/6)
up to 300 m
ce774-775.book Page 13 Tuesday, October 7, 2014 2:56 PM