Filter
Top Products
Actions Taken by the CS-104
MODE Result for correct Hot Key Incorrect Hot Keys
Scan • Filters out Hot Keys and beeps once
• Scans powered-on computers one-by-one and
flashes corresponding LED
• Scan rate is set by the DIP switches of the
first-stage CS-104
•
[Space]
stops this mode
Displays incorrect keystrokes
Previous/Next • Filters out Hot Keys and beeps once
• The right
[Shift]
key selects the next higher
numbered computer
• The left
[Shift]
selects the next lower num-
bered computer
•
[Space]
stops this mode
Displays incorrect keystrokes
Direct • Filters out Hot Keys and beeps once for a
ready port; otherwise, beeps twice.
• Switches to the selected port
Displays incorrect keystrokes
There is one
MANUAL LED,
and four
PORT STATUS LED
s on the front panel. The functions of
these LEDs are as follows:
MANUAL LED :
This LED turns on when the CS-104 is in
MANUAL
mode.
PORT STATUS LED:
These four (4) LEDs are used to indicate the various status conditions for any
given port.
1. If a port is not selected, its corresponding
PORT STATUS LED
will be off.
2. If a port is selected that is connected to another CS-104, its corresponding PORT STATUS LED
will flash:
3. If a port is selected that is connected to a “power-on” computer, its corresponding PORT
STATUS LED will remain lit.
4. If a port is selected that is connected to a “power-on” computer while in Previous/Next mode, its
corresponding PORT STATUS LED will flash:
5. If a port is selected that is connected to a “power-on” computer while in the Auto-Scan mode, its
corresponding PORT STATUS LED will flash:
LED On LED Off