Filter
Top Products
Chapter 6. Out of Band Operation
55
4. For the Connect using: field, select Direct to COM1 (assuming you are
using COM1 on your PC), then click OK. A Port Setting dialog box
similar to the one below comes up:
5. For OOBC connections, the SN0108 / SN0116's serial port settings and the
computer's COM port settings must be the same. Change the settings in
your dialog box (if necessary), so that they match the SN0108 / SN0116's
Console Port settings (seePort Config, page 31, for details), then click OK.
Note: The SN0108 / SN0116's default settings are 9600 bps; 8 Data bits;
No Parity; No Stop bits, but you can change these to something more
suitable to your installation as long as they both match.
sn816.book Page 55 Thursday, December 13, 2007 5:16 PM