Filter
Top Products
Chapter 7. Real COM Port Management
73
Linux Installation
Preparation
Before installing the driver file, make sure that the target you want to map is
on the network; that the port on the target you want to map is in Real COM Port
mode; and that your Linux IP address has been specified in the SN0108 /
SN0116's Direct Access dialog box (see Direct Access, page 39).
Installing the Driver
To install the driver file, first become root, and do the following:
1. Create a temporary directory in your system. For example, to create a temp
directory under root, at the # prompt use the following command:
mkdir /root/temp
Note: Under Linux, all input is case sensitive
2. On the software CD that came with your SN0108 / SN0116 package,
locate the file AtenVPInstall_vxxx.tgz (or download it from our website),
and copy it into the temp directory you just created.
Note: The vxxx specified above stands for the driver’s version number. The
file on the CD will show an actual version number.
3. At the # prompt, uncompress AtenVPInstall_vxxx.tgz with the following
command:
tar xvfz AtenVPInstall_vxxx.tgz
4. After AtenVPInstall_vxxx.tgz has been uncompressed, at the # prompt
issue the following command:
./AtenVPInstall.sh
5. Follow the on-screen instructions to install the driver.
Uninstalling the Driver
To uninstall the virtual port driver, as well as the daemon and device files, first
become root, and run:
/usr/lib/AtenVPort/AtenVPUnInstall.sh
This kills the daemon, and unloads the driver module from the kernel. It
modifies the rc file to eliminate self-starting of the daemon and auto-loading of
the module, and removes virtual port device files(/dev/ttyaxxx).
sn816.book Page 73 Thursday, December 13, 2007 5:16 PM